3/9/2024 0 Comments Logitech harmony kodi remoteI can still poke a hole through it for the IR receiver to work, but it’s a bit unconventionnal. ![]() But that’s strange, I though the cover was transparent enough for the IR signals to go through. It’s because the IR receiver of the N2+ is completely covered up when the cover is on. With the plastic cover removed, it works much better. It was because the Odroid box was on (I have the default Odroid box selled in the CoreElec pack). I also found why IR receiving by the Odroid was so much worse than all the others devices I have. Could someone help me to find why Power toggle was detected but not Power on ? But the Power on IR code wasn’t detected, I don’t know why. But I would prefer to have seperate buttons to turn on and off my Odroid. I succeeded to edit the config.ini and now the Power toggle can turn my Odroid on. When following the guide and executing ir-keytable -u, only the Power toggle code was detected. I maped my Odroid as Windows Media Center on my Harmony, and it has 3 IR codes registrered : Power on, power off and power toggle. I followed the guide How to configure IR wakeup code and it worked, but not fully how I want. Hi, I tried some new things and have some updates, but also some questions. Thanks for having read my post, and I thank you in advance for any answer. Is someone using the same remote as me ? Do you have tips and advices to make custom macros on it with an Odroid ? I get this might be a hardware issue, but is there some ways I could improve it ? What could be causing this ? Why is the receiving so good for all other devices and not the Odroid ? So navigating with the arrows while pointing the remote to the left is not great. It a problem because my setup is not in front of me when sitting, but on the left. But on the Odroid, I really need to be precisely pointing at it and less than 2m away from it. For all my other devices (AV Receiver, projector, Xbox One…) IR receiving works so good that the remote can be completely far away from the devices, anywhere in the room, not pointed at the device, and it will still work 90% of the time. I always have to unplug then replug the Odroid on. Tried with both, it doesn’t turn on by IR. This guide tells me to configure it as Windows Media Center in myHarmony, but it looks like Hardkernel Odroid N2+ is in their database too. I can’t figure out how to turn the Odroid on using IR.I tried following this guide : Logitech Harmony Setup. But I have some questions and I would like to ask what I could do to improve it. I recently got a Harmony 650, than I plan to use with all my setup (BenQ W1090 + Pioneer VSK527k + Odroid N2+ + Xbox One).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |